Wednesday, May 9, 2018

Reconfiguring Gerard Morin motor

Are you familiar with Gerard Morin
He uses a front loader washing machine pump motor which cost about $50 to buy. Now if you would like to make your own Gerard morin motor look at this example and understand. Of course we're not going to make cars out of paper, and it will be driven in a different way to.
You're going to need some ball bearings
A couple threaded bolts And their nuts 10.
At least two circular magnets or ring magnets just make sure that ring magnets fit over the threaded bolts.
Some duct tape
10 Fender washers, make sure they're not bigger than the ring magnet the same saws or smaller not too small so they go through the holes of the magnets, also make sure that the threaded bolts fit the fender washers
Okay this is what I'm going to give to you free, from the example to the parts and the sketch you should be able to figure it out if not then you can contact Media Library 313-651-5349 or email us at showmeyourproof1@gmail.com and you can buy a more detail with names diagram instead of a sketch. Keep in mind this is supposed to be a Gerard morin motor which we changed into an alternator, try using neodymium magnets. And play with different wire sizes to get the ultimate output remember the goal is to get 120 to 220 output at least now find you a electric motor to drive your alternator then upscale it by making more than one alternator for the motor to drive, remember each 120 volts is equal to a wall socket. And if you remember the switching trick then you understand adding a battery and switching back and forth between the alternator and the battery will give you the amps you need in this system you just made a small self ran generator, if you can figure out all the other small details we didn't tell you of course again I say this is what you get for free.

No comments:

Post a Comment